AQUATECH Aquajet ES Series Manuel du propriétaire télécharger pdf (Page 14)

W. S. Darley & Co. PuriFire™ 3S3P

Trusted Since 1908

NOTE: An activated carbon cartridge (Taste/Odor) may contain a small amount

of carbon fines (very fine black powder) and a new cartridge, after installation,

should be flushed with sufficient water to remove the fines before using the

water. Each time you use your water from your filtered water tap for drinking or

cooking purposes, it is recommended that you run (flush) the tap at least 10

seconds prior to using water. This is particularly important if the water tap is not

used daily.

NOTE: Certain types of harmless bacteria will attack cellulose material.

Cartridges containing cellulose may seem to disintegrate, produce a “musty” or

“moldy” odor, or form a black precipitate due to the bacteria. If you notice any of

the above problems while using the cellulose media cartridge, switch to a

synthetic media cartridge or consult the manufacturer.

NOTE: The replacement cartridge has a limited service life. Exhaustion of the

service life of those parts often cannot be easily detected. Commonly, it is only

after leakage has been observed or water damage has occurred that one is

made aware that the service life has been exhausted.

IMPORTANT NOTICE: To prevent costly repairs or possible water damage we

strongly recommend that the bowl or sump of all plastic housings be replaced

periodically: every five years for clear sumps, and every ten years for opaque

sumps. If your sump has been used for more than that the recommended period,

it should be replaced immediately. Be sure to date any new or replacement sump

for future reference and indicate the next recommended replacement date.

Cleaning UV 110

The quartz sleeve should be cleaned with warm soap and water every three

months.

UV bulb should be replaced every 9-12 months. The bulb does not normally burn

out, however the efficiency of the bulb decreases after one year.

Contact your local water treatment professional for replacement cartridge and

bulb pricing or call 1-800-645-0267 for a dealer near you.

Replacing UV Lamp and Filter

To ensure optimal performance from your PuriFire™ system and to protect your

warranty, use only genuine PuriFire™ filters and lamps available from your

PuriFire™ dealer.

UV lamp replacement

1. Turn off all electrical power to the system by unplugging or throwing the circuit.

2. Unscrew the UV control module from the mounting bracket (4 screws) for

Models UV-110

3. Slide the old bulb out and unplug from the control module.

NOTE: Hold the UV lamp only by the plastic covered ends of the bulb.

AQUATECH Aquajet ES Series Manuel du propriétaire Page 14