AQUATECH Aquajet ES Series Manuel du propriétaire Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
W. S. Darley & Co. PuriFire™ 3S3P
Trusted Since 1908
                                                                                                                                
5
GENERAL PRECAUTIONS
CAUTION: The PuriFire™ 3S3P unit is intended for purifying
uncontaminated surface freshwater only. DO NOT attempt to purify water
that is chemically, microbiologically unsafe or of unknown quality without
adequate treatment before or after the system.
WARNING: DO NOT attempt to purify and make safe drinking water from
seawater or saline water sources. DO NOT use for anything other than
purifying water. This Purifier is not intended to, nor does it soften or
remove all minerals from water.
WARNING: DO NOT use the Purifier if damaged, or if the electrical cord is
defective or wet.
WARNING: Use your Purifier on a dry, level surface, and well ventilated
area, away from other heat sources. DO NOT immerse electric part of the
Purifier in water.
NOTE: Replace the filter cartridge at least twice each year; replace the
ultraviolet bulb each year.
WARNING: DO NOT move the Purifier while it is operating; DO NOT
operate in a moving vehicle.
NOTE: When installing the water pump, positive voltage (+12 VDC) must
be connected to the red fused lead wire. Reversing polarity will instantly
blow the fuse and may permanently damage the controller.
WARNING: If you are uncertain with respect to any of this information,
PuriFire highly recommends that a qualified technician perform your
installation and determine the existing polarity of your current wiring.
WARNING: Never operate the pump in an atmosphere where flammable
gases may be present, since arcing at the motor brushes or switch
contacts may cause an explosion.
WARNING: After extended operation, or if malfunctioning, metal surfaces
of the pump may become hot and cause burns if touched. If this occurs,
disconnect electrical power and wait 30 minutes before touching pump.
WARNING: Never mount the pump where the surface temperature of the
motor or the controller (200 F maximum) may cause ignition of the
surrounding materials.
Vue de la page 5
1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Commentaires sur ces manuels

Pas de commentaire